User manual

SeaSTAR 3100LRS USER MANUAL

Issue 1.0 08/02

Reacquisition Delay it is possible to set

the delay used before the DSP reports a

loss of lock on the satellite signal. This is

done using the following command:

Mtreacdelay = none <CR>

Data Port selects the mode of output for

the Data Port. If DETECTOR MODE is

set to VBS then options for Data Port

output are :

SCF – Supercompressed Format

ERTCM – Enhanced RTCM, Wide Area

Corrections

NMEA – Messages output from GPS

Engine

Note : If detector mode is set to “RAW” then output is in

Supercompressed format (SCF). If set to “RTCM” then corrections for the

selected station(s) will be in standard RTCM SC-104 format.

If the ⇒ key is pressed again the User Settings menu option reappears.

Pressing the ⇓ key moves onto the next menu.

RECV →

ReacDelay = SHORT

RECV →

Data Port ERTCM

FSPAS Ref.: B31005102PMBRA0