Installation Guide

Outdoor Sun Shade

ASSEMBLY, INSTALLATION, CARE and USE INSTRUCTIONS

Installation Video available at www.shadeinfo.com

CUSTOMER SERVICE

Monday through Friday, from 7am - 4pm (MST). Please visit www.ShadeInfo.com to register your shade purchase.

IMPORTANT INFORMATION

We recommend two (2) people install this shade. Retain these instructions for future use. A power drill, tape measure,

leveling device, and Phillips screwdriver bit are recommended for installation (not included). Note: this shade must be

installed into wood studs. If woods studs are not available, anchoring hardware must be used (not included).

Tools required: phillips screwdriver, leveling device (laser level, standard level, etc.), and power drill (if pre-drilling the holes).

Note: your parts and fabric may dier in color than shown in this manual. Parts shown are not to scale. Pre-installed parts are not

shown in the part list below.

Crank Bracket

(CBC18)

Plug Bracket

(PB18)

Bracket Cover

(BC18)

Bracket Screws

(BSC18)

Pole

(PLP19)

Figure A

Parts in hardware box (parts not shown to scale)

PAGE 1
Outdoor Sun Shade ASSEMBLY, INSTALLATION, CARE and USE INSTRUCTIONS Installation Video available at www.shadeinfo.com CUSTOMER SERVICE Contact us at 303.652.6164 for additional information. English speaking customer service representatives are available Monday through Friday, from 7am - 4pm (MST). Please visit www.ShadeInfo.com to register your shade purchase. IMPORTANT INFORMATION We recommend two (2) people install this shade. Retain these instructions for future use.
PAGE 2
Your shade can be installed against a wall (Fig B) or against a ceiling/overhang (Fig C). Your shade is already prepared for a wall mount, with the crank on the right side of the shade. If you need to prepare your shade for a ceiling mount, or if you need to move your crank to the left side of the shade, please refer to the last page of this manual.
PAGE 3
Ceiling Mount or Left Crank Operation (or both) WALL INSTALL, CRANK RIGHT Your shade is prepared for a wall installation, with the Crank Bracket on the right side of the shade. See Figure J for the default bracket configuration. If you require the Crank Bracket on the left of the shade, or if you require a ceiling installation (or both), you will need to make a small change to your brackets. (DEFAULT SETUP) Figure J To change your brackets, remove both Bracket Covers (Fig K).