Installation Guide

Additional Optional Steps
Care & Maintenance
To clean your shade, simply rinse with water and soap, scrub with a so brush. Note: Using bleach or an abrasive clean-
er will void your warranty. Roll the shade down to air dry. Your shade should be rolled up during windy conditions.
To prolong the life of your shade, we recommend leaving one (1) roll of fabric wrapped around the top tube when using
your shade.
REVERSING THE ROLL DIRECTION OF YOUR FABRIC
e default fabric roll direction of your shade is “reverse”. at is, the fabric rolls from the back side of the top tube.
If you want the fabric to roll towards the front of your shade, simply roll your shade down until the fabric begins to
roll itself back up, towards the Valance. Note: if you reverse the roll direction of your fabric, you will need to move
your Ring so it does not interfere with the fabric.
MOVING THE RING FROM THE RIGHT TO LEFT SIDE OF THE SHADE
e default location for your Ring is on the right side of your shade. If you want to move the Ring to the le side of
your shade, please contact us for instructions on this process. e process takes approximately een (15) minutes.
MOVING THE RING FROM THE FRONT TO THE BACK OF THE SHADE
e default placement for your Ring is in the front of your shade. at is, the Ring is placed near the front of the
Valance (A). If you want to move your Ring to the back of the Valance, please contact us for instructions on this
process. Note: if you move the Ring from the front to the back of your Valance, you will also need to reverse the roll
direction of your fabric. e process takes approximately een (15) minutes.
Install Bungee System (optional step)
e shade includes two (2) Bungee Systems to secure the bottom of
both sides of your shade. To install the Bungee System, start by feeding
the Bungee through the Bottom Tube Plugs located at each end of your
Bottom Tube (Fig M). en insert the Bungee into the Hook and drill
the Hook into a wall/post using one (1) Bracket Screw (Fig N) from your
hardware box. To prevent fabric stretching/damage, hooks should be
installed directly underneath the Bottom Tube Plugs and so there is equal
tension on each bungee.
Important: Your shade should be rolled up during windy conditions. e
Bungee System is only eective in light wind. When using your shade, we
recommend leaving at least one (1) roll of fabric wrapped around the top
tube.
Fig M Fig N
4
303.652.6164 (phone)
www.shadeinfo.com
M1028-E
Additional information
An instructional video is available on our website (www.shadeinfo.com) if you need additional help installing or pro-
gramming your shade.
Don’t forget to send us your warranty/registration card.