Installation Guide

ManualsBrandsSeaSun ManualsOutdoor ShadesMorro Bay Elite PVC Fabric Outdoor Roller Shade Cordless Pole Operated with Valance - 96 in. W x 96 in. L

PARTS THAT ARE IN THE HARDWARE BOX

Valance Bracket (VB13) x 3

Bungee System (BUN09) x 2 Screw (S09) x 8

PARTS THAT ARE IN THE POLE PACKAGE

Ring (x1)

Lock Washer (large= x1 pcs)

(small=x2 pcs)

Pole Screw (x2)

Ring Screw (x1)

Note: some parts may be slightly dierent than shown in this manual.

CUSTOMER SERVICE

Monday through Friday, from 7am - 4pm (MST). Please visit www.ShadeInfo.com to register your shade purchase.

IMPORTANT INFORMATION

We recommend two (2) people install this shade. Retain these instructions for future use. A power drill, tape measure,

leveling device, and Phillips screwdriver bit are recommended for installation (not included). Note: this shade must be

installed into wood studs. If woods studs are not available, anchoring hardware must be used (not included).

Tools required: phillips screwdriver, leveling device (laser level, standard level, etc.), and power drill (if pre-drilling the holes).

Note: your parts and fabric may differ in color than shown in this manual. Parts shown are not to scale. Pre-installed parts are not

shown in the part list below.

Pole (PLP12) x 1

Exterior Pole Operated Sun Shade with Valance

Installation and Care Instructions

(Installation video available at www.shadeinfo.com)

Summary of content (4 pages)

PAGE 1
Exterior Pole Operated Sun Shade with Valance Installation and Care Instructions (Installation video available at www.shadeinfo.com) CUSTOMER SERVICE Contact us at 303.652.6164 for additional information. English speaking customer service representatives are available Monday through Friday, from 7am - 4pm (MST). Please visit www.ShadeInfo.com to register your shade purchase. IMPORTANT INFORMATION We recommend two (2) people install this shade. Retain these instructions for future use.
PAGE 2
STEP 1: Remove Protective Film from Valance Remove and discard the anti-scratch film that covers the Valance. STEP 2: Install Ring Using the Ring Screw and Lock Washer provided in the pole package, attach the Ring to the Crank Mechanism (Fig A). Fig A STEP 3: Determine Your Installation Type Determine your type of installation. Your sun shade can be hung from a wall or a ceiling. (Fig B) illustrates a wall installation, (Fig C) illustrates a ceiling installation.
PAGE 3
STEP 5: Install the Shade For wall installations, first hook the back of the Valance on the top of Valance Brackets (Fig H), then rotate the shade down and click it into place (Fig I). WALL INSTALLATION Note: you may need to push up on the spring-loaded plastic tabs on the Valance Brackets to help the shade click it into place.
PAGE 4
Install Bungee System (optional step) The shade includes two (2) Bungee Systems to secure the bottom of both sides of your shade. To install the Bungee System, start by feeding the Bungee through the Bottom Tube Plugs located at each end of your Bottom Tube (Fig M). Then insert the Bungee into the Hook and drill the Hook into a wall/post using one (1) Bracket Screw (Fig N) from your hardware box.