Installation Guide

Outdoor Pole Operated Sun Shade with PVC Fabric

INSTALLATION INSTRUCTIONS

Bungee Tie Down

(BUN09) x 2

Plug Bracket

(PBNV19) x 1

Crank Bracket

(CBNV19) x 1

Screws

(S09 x 6)

Parts in hardware box (parts not shown to scale)

Customer Service

Contact us at 303.652.6164 for additional information. English speaking customer service representatives are available Monday

through Friday, from 7am - 4pm (MST). Please visit www.ShadeInfo.com to register your shade purchase or to view an installation

video.

We recommend two (2) people install this shade. A power drill, tape measure, leveling device, and Phillips screwdriver bit are

recommended for installation (not included). Some parts shown in this manual may dier slightly than the product you have

purchased.

Part List

Please lay out and take an inventory of all parts prior to assembly. Please give us a call if you are missing any parts. Read the

instructions in their entirety prior to beginning assembly and installation. Note: this shade must be installed into wood studs. If

woods studs are not available, anchoring hardware must be used (not included).

Parts in pole package (parts not shown to scale)

Pole Screw (x2)

Lock Washer (large =1pcs)

(small =2pcs)

Ring (x1) Ring Screw (x1)

Using the Ring Screw, and Large Lock Washer provided in the pole package, attach the

Ring to the Crank Mechanism (Fig. A).

Step 1: Install the Crank Ring

Figure A

Wall Installation

Ceiling Installation

Figure B

Figure C

Your shade can be installed against a wall (Fig B) or against

a ceiling/overhang (Fig C). Your shade brackets are prepared

for a wall installation.

If you would like to prepare your shade for a ceiling installa-

tion, please see the last page of this manual for help preparing

the brackets.

Step 2: Determine Your Installation Type

Pg. 1

PAGE 1
Outdoor Pole Operated Sun Shade with PVC Fabric INSTALLATION INSTRUCTIONS Customer Service Contact us at 303.652.6164 for additional information. English speaking customer service representatives are available Monday through Friday, from 7am - 4pm (MST). Please visit www.ShadeInfo.com to register your shade purchase or to view an installation video. We recommend two (2) people install this shade.
PAGE 2
Step 3: Mark holes for installation An installation template has been provided to help position your pilot holes. To use the template, temporarily attach your template to your mounting surface (Fig. D ) and drill your pilot holes in the four shaded areas as shown in Figure E. Remove the template before moving to the next step. Figure D Figure E Step 4: Install Brackets Using the provided screws, install the Crank Bracket and Plug Bracket (Fig F and G).
PAGE 3
Ceiling Mount Bracket Adjustment (optional step) Wall Installation (Default) By default, your shade is prepared for a wall installation (Fig L). If you require a ceiling installation you will need to make a few small changes to your brackets. To change your brackets, begin by removing your bracket covers (Fig M). Remove the 2 screws from the Crank Bracket (Fig N) and the 3 screws from the Plug Bracket (Fig O).