Use and Care Manual

To clean your shade, simply rinse with water and soap and scrub with a soft brush. Note: using bleach or an abrasive cleaner
will void your warranty. Roll the shade down to air dry. Your shade should be rolled up during high wind conditions.
1010 Carbon Court, Unit D. Erie, CO 80516
303.652.6164 (phone)
Switching Cord to the Left Side of the Shade
If you want to reverse the roll of your fabric, simply roll the shade down completely. After the fabric is completely lowered,
continue rolling the shade.....it will roll itself back up in the opposite direction.
Maintenance
Reversing the roll direction of your shade
Don’t forget to send us your warranty/registration card.
1. Place your shade on the oor, with the front of the Valance towards you.
2. Remove both Valance Covers (RVC09 and LVC09). When removing the Valance Covers, use a blunt object to help remove
the covers. After you have removed the Valance Covers, switch their positions (move the left cover to the right side of the
shade, and move the right cover to the left side of the shade).
3. Next, remove both Brackets (Clutch and Plug) by loosening the screws and set the Brackets on the ground. It is not necessary
to completely remove the screws; you only need to loosen the screws. Do NOT reverse their positions.
4. Remove the Valance (leaving the shade on the ground) and reverse (turnover) the Valance so the front of the Valance is now
facing away from you. You do not need to reverse the shade. You reversed the Valance Covers earlier, so they are now on the
correct side of the Valance.
5. Replace both Brackets and both Valance Covers. IMPORTANT: when replacing the Brackets, be sure to push them in
completely before tightening the screws. The screws should align with the threaded screw holes.
www.shadeinfo.com
Additional information
An instructional video is available on our website (www.Shadeinfo.com) if you need additional help installing your shade.
M1022-E