Installation Guide

You can now control each shade individually by selecting their channel on your primary remote or you can control
all shades at the same time on the primary remote by lighting all ve (5) channels. Press the “channel increase” or
“channel decrease” buttons until all ve (5) channels are illuminated.
Programming Help
ERASING TOP AND BOTTOM LIMITS
If your top and bottom fabric limits programming did not work properly or you want to change them, see the
following instructions.
Before you begin this step, make sure your remote is on the correct channel for that shade. Additionally, we strongly
recommend that you use the original remote for your shade when erasing or changing limits.
1. Press the Program button on the remote one time (the motor will beep).
2. Press the “down” button one time (the motor will beep).
3. Press the Program button one time (motor will beep four times and fabric will jog),
Your top and bottom limits have been erased and you can now re-set them (see step 6).
Remember, all three buttons must be pressed within ten(10) seconds, or the motor will return to normal operation
mode. To set new upper and lower fabric limits, see step 6 for instructions.
Warning: If your remote has all 5 channels illuminated, you will erase the limits for all shades you are controlling
ERASING ALL FREQUENCIES ON THE REMOTE AND SHADE (and re-establish a connection)
If your remote and/or shade are not working properly, you can reset the remote and shade. is process will clear
the frequency of the shade and selected channel on the remote. It will also erase any top and bottom fabric limits you
may have set.
(If your shade motor does not respond to your remote during this step, skip to the
step B. Before you begin, make sure your remote is on the channel you wish to erase
(usually channel 1).
1. Press the Program button on the remote one time (the motor will beep and
the fabric will jog).
2. Press the stop button one time (the motor will beep and the fabric will jog).
3. Press the Program button one time (motor will beep several times and fabric
will jog). If this process worked correctly, your remote will no longer function.
Before you begin this step, make sure your remote is set to the channel you wish to
program for your shade (usually channel 1). Your shade battery must be charged for
this process to work.
1. To reprogram your shade you will need to press the green reset button (found
next to the antenna) for three seconds, (see Fig Y)
2. Once you release the button, the motor will beep (long beep) .
3. Press the Program button. e motor will beep and the fabric will jog.
4. Press the Program button. e motor will beep.
5. Press the “up” button (the motor will beep several times and the fabric will jog).
Your remote control is now programmed with your shade. Now you can set your upper and lower limits. See step
6 for these instructions. NOTE: If you accidentally press “down” instead of “up” during this process, the up/down
fuctions on your remote will be reversed. If this occurs, complete this process again starting with Step A.
Step A: Delete shade/remote connection and fabric limits
Step B: Re-establish shade/remote connection
Fig Y
7