Installation Guide

Corded Shade with PE Fabric
Description Part Number Qty Included
Clutch Bracket CB9 1
Plug Bracket PB9 1
Bracket Cover BC9 2
Clutch with cord (pre-installed) C9 1
Plug with pin (pre-installed) P9 1
Bottom Rail (pre-installed) BR9 1
Bottom Rail Caps (pre-installed) BRC9 2
Fabric F9 1
Screws (not shown) SCR9 6
Cord Safety Device CSD17 1
Bottom Rail Ring (pre-installed) BRR9 2
INSTALLATION INSTRUCTIONS
Maintenance
To clean your shade simply rinse with water and scrub with any non-abrasive cleaner (us-
ing bleach or other abrasive cleaners will void your warranty). Roll the shade down to air
dry.
Step 4: Install Cord Safety Device
The Cord Safety Device keeps the Cord secure and reduces the risk of
strangulation. This is a very important step, we strongly recommend
that you utilize your Cord Safety Device. Note: You must install
this device for your shade to work properly The Cord Safety
Device is pre-installed on the Cord.
Make sure the cord is tight before you secure the Cord Safety Device. To secure the Cord
Safety Device, drill two (2) Cord Safety Device Screws into a wall/post (Fig L). If a wood
stud is not available, you will need to use an anchor (not included). See your local hard-
ware store for more information. Note: Your Cord Safety Device may look different than
the one pictured in gure L. The installation process however, is the same.
303.652.6164 (p)
Figure L
Moving Cord to left side of the shade
Clutch Bracket
(CB9)
Figure A
M1021-E
Securing your shade
Your shade has Bottom Rail Rings pre-installed on
the Bottom Rail. These rings can be used to secure
your shade during slightly windy conditions. You
may use a screw, nail, S-hook, or any other device to
secure your shade. (Fig O)
Clutch (w/ cord)
(C9)
Plug (with pin)
(P9)
Plug Bracket
(PB9)
Bottom Rail Cap
(BRC9)
Cord Safety Device
(CSD17)
Bottom Rail Ring
(BRR9)
Bracket Cover
(BC9)
Fabric
(F9)
Bottom Rail
(BR9)
Tools required: phillips screwdriver, leveling device (laser level, standard level, etc.), and
power drill (if pre-drilling the holes).
Your shade is already prepared for the Cord to be located on the right side of the shade. If
you want to move the Cord to the left side of the shade, remove the plug bracket cover (Fig
M.), loosen the screws. Then you will need to rotate the metal disc in the Plug Bracket
(Fig N). Tighten the screws then replace the plug bracket
No change is needed to the Clutch Bracket, you only need to rotate the Clutch so the Cord
hangs down, towards the ground. You are now ready to install you shade with the cord on
the left side.
www.shadeinfo.com
Note: your parts and fabric may differ in color than shown in this manual
Figure N
Don’t forget to send us your warranty/registration card.
Figure M
Figure O