Installation Guide

ManualsBrandsSeaSun ManualsOutdoor ShadesPremium PVC Fabric Exterior Roller Shade Cordless Crank Operated with Protective Valance - 96 in. W x 96 in. L

Pole Operated Exterior Sun Sade (with Valance)

PARTS THAT ARE PRE-INSTALLED

Valance (VA10) x 1

Shade Cloth (SC) x 1

Bottom Tube (BT09) x 1

Bottom tube plug

(BTP09) x2

Exploded View

PARTS THAT IN THE HARDWARE BOX

Valance Bracket (VB09) x 3

Bungee System (BUN09) x 2 Screw (S09) x 8

PARTS THAT IN THE POLE PACKAGE

Pole Handle Piece (PHP12) x 1

Pole-Mid Piece (PMP12) x 1

Pole-Long Piece (PLP12) x 1

Ring (R12) x 1

Lock Washers

(PLW12) x 3

Pole Screw

(PS12) x 2

RingScrew

(RS12) x 1

Le Valance Cover

(LVC09) x1

Plug Bracket

(PB10) x1

Plug with pin

(P10) x1

Right Valance Cover

(RVC09) x1

Crank Bracket

(CB12) x1

CrankPlug

(CP12) x1

Note: some parts may be slightly dierent than shown in this manual. We recommend two (2) people install this shade.

To view installation video, please visit https://shadeinfo.com/video-tutorials/

Summary of content (4 pages)

PAGE 1
Pole Operated Exterior Sun Sade (with Valance) To view installation video, please visit https://shadeinfo.
PAGE 2
Install Ring Before you install your Valance Brackets, you will need to install the ring onto the Crank Bracket. Using the Ring Screw provided in the pole package, attach the Ring to the Crank Bracket. See Fig A. Be sure to tighten this screw completely. Fig A Step 1: Install Valance Brackets Wall Installation Ceiling Installation Determine your type of installation. Your solar shade can be hung from a wall or a ceiling. See Figures B and C.
PAGE 3
Step 2: Install the shade Wall Installation For wall installations, first hook the back of the Valance on the top of Valance Brackets (Fig H), then rotate the shade down and click into place (Fig I). Note: you may need to push the plastic tabs on the Valance Brackets to help the shade click into place. Fig H Fig I Ceiling Installation For ceiling installations, first hook the back of the Valance on the back of the Valance Brackets (Fig J), then rotate the Valance upwards and click it into place (Fig K).
PAGE 4
Install bungee system Your shade includes two (2) Bungee and Hooks to secure the bottom of your shade. To install the Bungee System, start by feeding the Bungee through the Bottom Tube Plugs located at the end of your Bottom Tube (Fig M). Then insert the Bungee into the Hook and drill the Hook into a wall/post using one (1) screw (Fig N) from your hardware box. Important: Your shade should be rolled up during windy conditions. The Bungee System is only effective in light wind.