Owner`s manual

11Introduction
Depending on the unit and the country, on turning the engine off or remov-
ing the vehicle key the unit will switch itself off automatically. In turning the
unit back on, it will turn off automatically for approximately 30 minutes
(timeout).
Energy management
If, when the ignition is switched off and the unit switched on, the battery
voltage falls below the minimum onboard power supply voltage, there is an
audible warning and LOW BATTERY appears. The unit should be switched
off.
If the battery voltage level continues to fall, RADIO OFF is briefly displayed
and the radio will switch itself off automatically.
Anti-theft code
The numerical code of the anti-theft coding system is stored once it has
been entered in the vehicle for the first time (radio convenience coding).
When it is necessary to manually deactivate the anti-theft code, for example
when installing the unit in another vehicle, please visit an official SEAT deal-
er.
If it is just the battery that has been disconnected from the vehicle, the vehi-
cle must be started before turning the unit back on.

Adjusting the base volume
Function
Action
Increase the vol-
ume.
Turn the volume control  ⇒ fig. 1
1
clockwise or press
the button on the multifunction steering wheel ⇒ Book-
let Instruction manual, chapter Vehicle diagram.
Lower the vol-
ume.
Turn the volume control  anti-clockwise or press the
button on the multifunction steering wheel.
Changes to the volume are indicated by a “bar” on the screen.
At “0” the unit is muted (display: ) and any media source currently being
played will be stopped.
It is possible to preset certain volume settings and adjustments
⇒ page 30.
Note
If the basic playback volume of an audio source has been increased sub-
stantially, lower the volume before changing to another audio source.
