User's Guide

15
Step 5: Cable layout
After the indoor and outdoor antenna and the main machine are installed and
fixed, connect the antenna with the port of the main machine by cable. The
distance between the port of the main machine and the indoor and outdoor
antenna should be wired in the shortest way.
The steps are as follows
(1) Disassemble the cable package and place it so that it can bend naturally
and smoothly.
(2) One end of the cable is screwed together with the antenna port, and the
cable is kept natural and smooth. The cable is fixed on the wall with a fixing
clip every 1-1.5 meters in the direction of the indoor host, and the other end
of the cable is connected with the host port.
(3) the vertical place of the cable wiring should be naturally bent to avoid
damage caused by the strong pull of the cable.
(4) Tighten the antenna and the cable port, and the cable and the host port to
ensure good contact of the interface.
(5) The cable end is waterproof and moisture-proof to avoid water oxidation,
which will lead to the reduction of indoor signal coverage area.
(6) Complete cable layout.
Step 6: Optimize the mainframe power test
After completing the installation steps above, check the following notes
(1)Minimum vertical distance between outdoor and indoor antennas is 25 feet
and minimum straight-line distance is 40 feet.
(2) The orientation of the outdoor antenna should not point to the indoor
antenna.
(3) The OUTDOOR antenna and INDOOR antenna are properly connected to
the host port. The OUTDOOR antenna is connected to the host "OUTDOOR"