User's Manual

Frequently used menus

2.5 Correlation analysis menu

Tapping the Correlation curve always opens the following menu which provides tools

for analysing the correlation.

Zoom … to magnify a section of the curve

Tap the button, then mark the area to be magnified in the diagram,

i.e. tap and draw out the required range.

Zoom-Reset … to reset the curve to its initial state

Magnification and suppression are abolished. The entire correlation curve

is displayed.

Zoom opt. … to magnify the curve optimally, relative to the measuring

distance

Exactly the part of the correlation curve is shown, which refers to the pipe

between the two measuring points.

Move cursor … to read the lag value or the distance to the leak at any

point of the curve

Tap the button, then move the vertical red line in the diagram.

Suppress … to hide a section of the curve

Tap the button, then mark the area to be suppressed in the diagram,

i.e. tap and draw out the required range.

Suppress individual audio blocks (only Offline measurement)

Opens a menu showing the 10 single correlations of this pair of sensors.

"Bad" single-correlations can be 'deactivated' and, by this means,

excluded from the total-correlation.

Tap the button. In the menu that opens, tap the required fields to

remove/set the checkmark. Use the Back button to return to the

correlation analysis menu.

Pause

Interrupts the current correlation.

Continue

Continues the interrupted correlation, but does not reset the averaging.

Refresh

Resets the averaging and restarts the correlation.

Store

Opens the Correlation management menu to store the displayed

correlation data in the Correlator's data base.