User's Manual

The Correlator

For entering a device ID the following screen view, or a similar one, opens:

DEL

… Deletes the last character

ENTER

… Confirms and completes the input

… Accepts and enters the automatically detected ID

Decline

… Does not accept the automatically detected ID

Finish

… Completes the automatic detection

For the manual entry of IDs, the number pad displayed is used. Confirm your entry with

the ENTER button.

When inputting an ID, the preceding zero digits can be omitted.

Thus, if the ID is ‘000225’, you need only enter ‘225’.

To the right of the number pad, there are fields and buttons for the automatic sensor

detection. The devices concerned must be close to the correlator.

To register a Power transmitter to the correlator, briefly press the I/O pushbutton of the

device. To register a Multi sensor, briefly move a magnet past the sensor's I/O area, so

that the LED lights up briefly. As a result, the device's ID is sent, detected by the

Correlator and displayed there. Use the provided buttons to accept or decline the ID.

This way, multiple sensor IDs can be registered to the Correlator in quick succession.

4.4.3 Entering text

To input comments or similar, a virtual keyboard appears on the screen. Enter the

required text and confirm with OK.

Manual entry

Automatic detection