User's Manual

The Correlator
38
4.5 Commissioning
4.5.1 Switch the correlator ON/OFF
The correlator is switched on with the I/O pushbutton . The boot process takes a few
seconds, then the Start menu appears on the screen. The device is now ready.
To switch the correlator off, press the I/O pushbutton until the screen turns off
(approx. 2 seconds).
The Commander automatically switches off if no input is made within a specified time
period. This timespan can be configured in the system settings.
4.5.2 Basic settings at initial start-up
When the correlator is switched on for the first time, two consecutive 'Welcome menus'
appear on the screen. There, some basic system settings have to be made before the
Start menu can be entered.
In the menu that appears first, use the upper pull-down list to select your language. The
Correlator's operating language immediately adapts to your selection. After that, give the
remaining requested details.
Line Description
Daylight saving time
Select whether currently is winter or summer time.
Date format
Select a format for the correlator's system time.
DD
MM
YYYY
…
…
…
Day
Month
Year
Date / Time
Enter the current time (hours:minutes:seconds) and date
(day:month:year).
Confirm with OK. The menu is closed. The settings are accepted. You have the chance
to change these settings again in the Correlator's system settings menu, at any time.
Switching ON
Switching OFF
Auto-OFF
Language,
date and time