User's Manual

GPS position data
73
11 GPS position data
11.1 Introduction
You can use the Correlator to determine and store the GPS coordinates of the individual
measuring points.
GPS data facilitate the management and analysis of the measured data in the Offline
measurement. For some analysis capabilities GPS data are even a prerequisite.
The GPS receiver LOG GPS-3 has to be connected to the Correlator.
The GPS module is connected using the USB/GPS socket . Observe the markings
on the plug and socket. You must feel the plug engage. The GPS module is powered via
the USB connection. The device switches on immediately after connection and is ready
for operation. The status LED lights up. The device is detected automatically by the
Correlator. Further settings are not required.
11.2 Determine and save GPS coordinates
To determine the GPS position for a sensor, you must take the Correlator and proceed
as close as possible to the installed device.
Proceed as follows:
Step Description
1
In the main menu, tap the button .
2 In the displayed menu, tap the Store GPS position button.
Result: The following menu is opened. The up to 8 fields represent the sensors
registered to the Correlator's "Multisensor pool".
(continued on next page)
Requirements
Sensor ID
Sensor no.
GPS position