User's Manual

Programming the logger
45
6.2.1.2 Configuring a ‘user defined’ sensor
In the case of a ‘user defined’ sensor which is not contained in the mentioned
Drop-Down-List, the input type (carrier) and the unit of the physical value have to be
specified manually. Furthermore, the upper and lower thresholds of the input signal and
the correlating measurement values have to be specified.
Perform the following steps to configure the input type of a ‘user defined’ sensor:
Step Description
1
Select the type of signal, the sensor uses to pass the measured data to the logger
from the Input type drop-down list.
2
Select the unit of the physical value measured by the sensor from the Unit drop-
down list.
3
Depending on the selected input type and value, some additional fields may need
to be populated with the upper and lower thresholds of the input signal and the
correlating measurement values.
For detailed information about the input type and the ranges, please refer to the
manual of the connected sensor.
Introduction
Configuring the
input type
Input signal thresholds Correlating measured values