User's Manual

Retrieving and evaluating data
62
7.4 Displaying measurement data
7.4.1 Calling up a measurement
To call up the most recently saved measurement data of a device, double-click this
device in the directory tree of the software. The window for displaying the measurement
data opens (see below).
To call up the results of a particular measurement, proceed as follows:
Step Description
1
Select the relevant device in the directory tree.
2 In the menu bar in the segment Measurement data, click on Show data.
Result: The data records list opens.
If only one measurement data record is saved for this device, this list does not
appear. Instead, the measurement data display opens immediately.
3 Select the required data record in the list and click Show or double-click the
concerning line.
Result: The measurement data is shown.
7.4.2 Using the measurement data display
The following figure shows the window for displaying measurement data:
In the top diagram the entire measurement is displayed. Up to four different coloured
curves can be seen. Each curve is representing the results of one of the logger’s
measuring channels.
The bottom diagram is used for viewing enlarged subareas of the measurement curves
(known as the “ZoomView” – see below).
The X-axis corresponds to the chronological sequence of a measurement. The Y-axis
corresponds to the measured values.
To focus on the data of one measuring channel you can either select the channel from
the blue info window on the right or click directly on the respective curve in the bottom
diagram.
Calling up the most
recent measurement
Calling up a particular
measurement
Design
Selecting a channel