User's Manual

Working in Easy mode

5.1.3 Defining a workgroup

More than one group of loggers can be registered in the Commander. However, the

Commander can only work with one of these groups at a time. This group is called the

“workgroup”.

Specify the workgroup for the impending measurement session. Please proceed as

follows:

Step Description

In the main menu, select the System settings button.

2 In the next menu, select the Change group button.

Result: A list with all the registered logger groups opens.

The current workgroup is indicated by an X.

Select a logger group for the measurement session.

Result: The selected group is now registered in the Commander as the

workgroup. In the main menu, the name of the workgroup is shown at the

bottom left of the display area.

Each logger group in the list has already been assigned its group mode (see

page 13).

Groups with an “L” before the name can only be read using “Lift & Shift”, i.e. all

the loggers in the group are collected and then read together.

Groups with a “P” before the name can only be read using “Patrol”, i.e. all the

loggers in the group remain in the shaft and are read on location individually.

The loggers of a group with an “N” before the name are networked together and

connected to a GSM-Box. These loggers can’t be read by a reading device but

send their data regularly to a FTP server.