User's Manual

Working in Easy mode

5.2 Programming the loggers

The loggers in the workgroup must be reprogrammed before each session. This means

that the Commander sends basic data for the session wirelessly to the loggers (e.g. the

measuring window).

To program the workgroup proceed as follows:

Step Description

In the main menu, select the Prepare loggers button.

Result: The workgroup is shown. The name of the group is at the very top of

the display, and all the loggers in the group are listed underneath.

2 Select the Prog. Group button.

Result: The next step is shown.

Switch off all the loggers in the group, i.e. place them “on their head” for about

three minutes.

As an aid, a three-minute countdown on the screen can be started with the

Start button.

Then select the OK button.

Result: The next step is shown.

(continued on the next page)

Introduction

Procedure