User's Manual

Working in Professional mode

6.3 Programming the loggers

Each logger must be configured before each measuring session. They are assigned

with all the relevant parameters before the impending measurement.

Even loggers that have already been programmed and installed can usually be

reprogrammed. However, to save power, all loggers in group mode “Patrol” can

only receive the Commander’s signal every 10 seconds, even in the time when

they are ready for wireless operation. It can therefore take a very long time to

program these loggers.

Where possible, we recommend that all the loggers are changed to configuration

mode before programming, i.e. to switch them off for at least 3 minutes and then

to switch them back on again. Loggers can be reliably programmed in

configuration mode.

Proceed as follows to open the configuration window for a logger:

Step Description

Select the symbol in the main menu bar.

2 In the next menu, select the Program Logger / Group button.

Result: The menu for logger programming opens. The loggers in the current

workgroup are listed here.

If you would like to program loggers not in the workgroup, you can use the drop-

down list at the very top of the screen to call up another registered logger

group.

If you wish to program all the loggers i

the displayed group, apply the

Prog. Group button.

If you wish to program a single logger

in the group, first select the list and

then choose the logger. Then apply the

Prog. Single button.

Result: The input window for configuring the loggers opens on the screen.

Introduction

Opening the

configuration window