User's Manual

Working in Professional mode

Proceed as follows to continue the programming process:

Step Description

Enter the data in turn for the group or the single logger.

2 Apply the Program button in order to finish the programming.

Result: The configuration data is

transferred from the Commander to the

group.

A new view opens on the screen with

two windows:

The left-hand window shows the

loggers in the group that have been

successfully programmed.

The right-hand window shows the

loggers that have yet to be

programmed.

The antenna symbol indicates that the

Commander is wirelessly operational.

The Stop and Start buttons can be

used to cancel and continue the

procedure at any time.

Data transfer ends automatically once

all the loggers in the group have been

successfully programmed.

Result: The configuration data is

transferred from the Commander to the

individual logger.

A blue bar shows the progress of the

data transfer.

From now on, do not place the loggers on their head because switching

off would cause them to lose their configuration data and they would

need to be reprogrammed.

If a logger could not be programmed, it may have been switched off, not ready

for wireless operation or it was outside the Commander’s wireless range.

The loggers are now ready to be installed for use on location.

6.4 Installing the loggers

You can find detailed information on installing the loggers in the previous chapter (see

page 35).

Continuing

programming