User's Manual Part 2

Working in Professional mode

6 Working in Professional mode

6.1 Starting up the Commander

6.1.1 Switching on the Commander

Use the I/O button to switch on the Commander.

The Professional mode start image appears on the screen:

If the symbol is shown at the bottom in the middle of the screen, the

Commander is not in Professional mode but Easy mode instead. To switch to

Professional mode, open the system settings menu. Beginning at the start screen, follow

the  symbols and, in the first line of the menu, select the “Professional

mode” setting from the list.

The screen might not be displaying the correct language. The language can be changed

in the system settings. Beginning at the start screen, follow the  

symbols and select your language from the list.

6.1.2 Checking the system settings

Before a measuring session, check that the Commander’s system settings are up-to-

date and correct (see page 25). The date and time settings in particular must be correct.

6.1.3 Registering loggers in the Commander and specifying the

workgroup

The loggers to be used for an impending measurement must be registered and

combined in a group (see page 23) in the Commander.

To specify the workgroup (see page 14), select the symbol in the main menu bar,

open the Group Management menu and select a group in the list of registered logger

groups (marked with an X).

However, a lot of menus in Professional mode also have a drop-down list at the very top

of the screen. It can be used to access a group list directly and select a workgroup.

Switching on

Changing the

user mode

Changing the language

Main menu bar

Firmware version,

System date,

Identification number of

the Commander

Workgroup