User's Manual

LOG N-3
21
4.2.3 Reading out single loggers
To read out measured data from an individual logger, proceed as follows:
► In the start screen, tap LOG N-3.
► Tap Single device.
► Select the desired logger from the Devices list.
► Tap Measurement data.
The connection to the logger is established. The data is received by the PocketServer
and displayed on the screen.
After closing the measurement data display, you will find this data record in the Data list.
It can be accessed and displayed there at any time.
4.3 Displaying measurement data
All read measured data is stored in the PocketServer and can be accessed and
displayed at any time.
4.3.1 Data of a Patrol group
To access the measured data of a Patrol group, proceed as follows:
► In the start screen, tap LOG N-3.
► Tap Patrol mode.
► Select the desired logger group in the Groups list.
► Select the desired measured data from the Data list.
On the screen, the Session area opens.
On the left, all loggers are listed using their ID.
In the middle, a coloured symbol indicates whether the logger is in the alarm state.
GREEN … no alarm.
RED … alarm! Leak threshold exceeded
On the right, you will find the minimum ESA value of the respective logger.
When you tap the coloured icon next to a logger ID, an additional line is shown/hidden.
In this line you will find:
 Level and frequency of the leak noise of this logger
Displaying the
minimum values