User's Manual

LOG N-3
28
4.4 Reading out audio files
If you want to listen to the sound of a logger, you must read out the audio file of this
noise from this logger.
Requirement:
 The corresponding logger must not have been switched off since the measurement.
Procedure:
► In the start screen, tap LOG N-3.
► Tap Single device.
► Select the desired logger from the Devices list.
► Tap Audio.
The connection to the logger is established. The audio file of the last measurement is
received by the PocketServer. The following operating panel appears on the screen:
► Tap the play button if you want to listen the leak noise.
The 3-second recording is played by your mobile device. Use the slider beside the
speaker icon to adjust the volume of the playback.
After leaving the audio menu, you will find this audio record in the Data list. It can be
accessed there and the leak noise played back again at any time.
INFO
Using Microsoft Internet Explorer may cause problems with playing the audio files. In
this case, please open the PocketServer user interface in another browser.
4.5 Reading out a configuration
You can read out the current configuration of a logger. The measurement and wireless
settings and the general status information of this logger are queried.
► In the start screen, tap LOG N-3.
► Tap Single device.
► Select the desired logger from the Devices list.
► Tap Settings.
The connection to the logger is established. The data is received from the PocketServer.
On the screen, you will find the data in these drop-down menus:
 Firmware
Currently used firmware version of the logger
 Battery
Battery level (full/good/OK/poor) and battery voltage of the logger
 Time
Internal date and time of the logger (at the readout time)
Device info