User's Manual

LOG P-3 / P-3 mini
39
► Tap the button .
► In the context menu, tap Delete.
► Select the desired logger from the Devices list.
► Answer the confirmation prompt with OK.
The logger disappears from the device list. All data of the logger are deleted from the
PocketServer.
► Tap the button .
5.2 Reading the measured data
To read out the measured data, proceed as follows:
► In the start screen, tap LOG P-3/LOG P-3-mini.
► Select the desired logger from the Devices list.
► Tap Measurement data.
► Decide whether All data or New data only will be read out.
‘New data only’ means: Only the measurement data that has been recorded since the
last reading is read out.
‘All data’ means: All measured data saved in the logger is read out.
The connection to the logger is established. The data is received by the PocketServer
and displayed on the screen.
After closing the measurement data display, you will find this data record as a new entry
under Data. It can be accessed and displayed there at any time.
5.3 Displaying measurement data
Read-out measured data is saved in the PocketServer. To access a measurement
record, proceed as follows:
► In the start screen, tap LOG P-3/LOG P-3-mini.
► Select the desired logger from the Devices list.
► Select the desired measured data from the Data list.
The measurement data display opens. The graph of the measurement is displayed as a
curve. Each point on the curve corresponds to a measured value.
Deleting loggers