User Manual
Table Of Contents
- II Installation
- 2.1 Mounting
- 2.2 Connections
- Figure 1 Figure 1A
- Series 600HS units are gasket-sealed. Changes or adjustments to the operating modes of any unit are accomplished internally:
- 1) To gain access, (Disconnect power from the unit before opening) remove the 5 outer black hexagonal head screws retaining the connector plate as shown in Figure #4. Then remove the 4 screws surrounding the connector. This will enable the removal of ...
- 2) After removing the screws, lift the panel to expose the internal components as shown. Figure #5 shows the adjustments and their locations
- Figure 1 Figure 1A
