User's Manual

ManualsBrandsSECO-LARM USA ManualsSecurity Cameras3x

Note: Products with model numbers that end with “Q” or that have a round green “Q” sticker are RoHS compliant.

Installation Manual

Elite 3X Vandal Dome Cameras

For Flush or Surface Mount

3 Cameras in 1:

EV-2866-NKGQ

NTSC

EV-2866-PKGQ

PAL

” Sony Super HAD II CCD

600 TV Lines

12VDC/24VAC

2.8~12mm Varifocal lens

256x Digital slow shutter

On-screen display (OSD)

Summary of content (4 pages)

PAGE 1
Elite 3X Vandal Dome Cameras For Flush or Surface Mount Installation Manual EV-2866-NKGQ EV-2866-PKGQ NTSC PAL 3 Cameras in 1: 1 /3 ” Sony Super HAD II CCD 600 TV Lines 12VDC/24VAC 2.8~12mm Varifocal lens 256x Digital slow shutter On-screen display (OSD) Note: Products with model numbers that end with “Q” or that have a round green “Q” sticker are RoHS compliant.
PAGE 2
Elite 3X Vandal Dome Cameras for Flush or Surface Mount Specifications: Type Video Output Mode Pickup Element Resolution Lens (Varifocal) # of Infrared LEDs Effective Pixels Video Output Minimum Illumination S/N ratio On Screen Display (OSD) Motion Detection Backlight Compensation White Balance Digital Slow Shutter (DSS) Electronic Shutter Auto Gain 3-DNR (DNR with 3D filtering) Day & Night (color) Sharpness Privacy IP Rating Operating Voltage LEDs OFF Current Draw LEDs ON Operating Temperature Dimensions
PAGE 3
Elite 3X Vandal Dome Cameras Overview: OSD joystick Service monitor port BNC connector Camera Set screw Dome Base (For surface mounting only) Rubber ring DC Plug to terminal block DC Jack Important: Do not cut the DC jack or the female BNC connector as this will void the warranty. Before Starting: 1. Please read this manual carefully and keep it for future reference. 2. Use the camera within given temperature and electrical limits. 3. Do not aim the LEDs directly at the eyes when the LEDs are on.
PAGE 4
Elite 3X Vandal Dome Cameras for Flush or Surface Mount Troubleshooting: The screen is blank. Check that the camera is powered up. Check that the power supply’s polarity is correct. Check that the monitor is powered up. Check that the video cable connecting the camera to the monitor is connected properly. The screen image is dim Clean the lens using a soft, clean cloth. Check that the light source is adequate. The screen image has poor contrast. Adjust the monitor’s contrast knob.