Enforcer RF Receivers Installation Manual

ManualsBrandsSECO-LARM USA ManualsStereo ReceiverEnforcer RF Receivers SK-910R

ENFORCER

SK-910 SERIES

RF RECEIVERS

SECO-LARM

Model

SK-910R ...............One-channel receiver, 315MHz

SK-910RL ............. Low-voltage, one-channel receiver, 315MHz

SK-910R2 .............Two-channel receiver, 315MHz

SK-910R-4 ............ One-channel receiver, 433.92MHz

SK-910RL-4 ..........Low-voltage, one-channel receiver, 433.92MHz

SK-910R2-4 .......... Two-channel receiver, 433.92MHz

Summary of content (4 pages)

PAGE 1
ENFORCER ® SK-910 SERIES RF RECEIVERS Model SK-910R ............... One-channel receiver, 315MHz SK-910RL ............. Low-voltage, one-channel receiver, 315MHz SK-910R2 ............. Two-channel receiver, 315MHz SK-910R-4 ............ One-channel receiver, 433.92MHz SK-910RL-4 .......... Low-voltage, one-channel receiver, 433.92MHz SK-910R2-4 .......... Two-channel receiver, 433.
PAGE 2
System These RF receivers are compatible with both code hopping and fixed-code transmitters (see page 4 of this manual for a list of compatible transmitters). They can be used for a variety of applications, such as allowing the same transmitter to arm/disarm a vehicle alarm and open/close a garage door opener. The receivers come in one- or two-channel versions. Each channel can learn the codes of up to 15 different transmitter buttons on a first-in, first-out basis. Installation Notes 1.
PAGE 3
Mode Switch Operation (one per channel) • Learn mode — Press and hold the switch for three seconds. • Clear memory — Press three seconds, then when the LED starts flashing, press again for three seconds to delete all previously learned codes. • Reset latched output — If this channel was programmed for latch output, once the relay is turned on with a transmitter button, press the mode switch to turn the relay off. • Memory Display — Press and release the mode switch to show number of codes stored.
PAGE 4
Typical Applications: Positive Output: COM NC NO + 12VDC receiver power driving a 12VDC apliance: Positive Power Output } Power for SK-910R Negative Power Source Negative Power Output } 12VDC O/P GND Power for SK-910R +12VDC } 12VDC receiver power input, 24VAC output driving a motor Negative Output: COM NC NO + COM NC NO + Positive Power Source Power for SK-910R COM NC NO + 24VAC(1) Input 24VAC(2) 24VAC(1) Output GND +12VDC 2 Motor 1 General Specifications Operating Frequency: 315 MHz