User's Manual

ManualsBrandsSECO-LARM USA ManualsSecurity CamerasEV-122C-FVB3Q

Manual

Note: Products with model numbers that end with “Q” or that have a round green “Q” sticker are RoHS compliant.

Flush-Mount Low-Profile

UFO Camera

Model

Video Output

Resolution

EV-122C-FVB3Q

NTSC

480 TV Lines

EV-6640-N3WQ

NTSC

600 TV Lines

EV-122C-PVB3Q

PAL

480 TV Lines

EV-6640-P3WQ

PAL

600 TV Lines

 Small size - only 3” diameter



” Sony Super HAD II CCD

 3.7mm Pinhole lens

 Low 0.05 Lux rating

 Lens rotates to nearly any angle

 Low-profile design blends into nearly

any décor

 Vandal-resistant metal housing

Summary of content (4 pages)

PAGE 1
Flush-Mount Low-Profile UFO Camera Manual Model EV-122C-FVB3Q EV-6640-N3WQ EV-122C-PVB3Q EV-6640-P3WQ Video Output NTSC NTSC PAL PAL  Small size - only 3” diameter  1/3” Sony Super HAD II CCD  3.7mm Pinhole lens  Low 0.
PAGE 2
ENFORCER Flush-Mount Low-Profile UFO Camera Specifications: NTSC PAL Type Image sensor Resolution Lens NTSC Pickup elements PAL Sync Video output Minimum illumination S/N ratio Shutter control Gain control White balance Gamma correction Operating voltage Current draw Operating temperature EV-122C-FVB3Q EV-6640-N3WQ EV-122C-PVB3Q EV-6640-P3WQ Flush-Mount Low-Profile UFO Camera 1/3” Sony Super HAD II CCD 480 TVL 600 TVL 3.7mm 510x492 pixels 768x494 pixels 500x528 pixels 752x582 pixels Internal 1.
PAGE 3
ENFORCER Flush-Mount Low-Profile UFO Camera Overview: Screw Base Ring bracket (1 Shown, 3 included) (inside the ceiling wa l) Camera ball Flange Female BNC connector DC Plug with terminal block Flange Base DC Jack Ring bracket Before Starting: 1. Please read this manual carefully and keep it for future reference. 2. Use the camera within given temperature and electrical limits. 3. Do not mount the camera where it is exposed to rain or other moisture, or in humid or dusty places. 4.
PAGE 4
ENFORCER Flush-Mount Low-Profile UFO Camera Troubleshooting: The screen is blank.     Check that the camera is powered up. Check that the power supply’s polarity is correct. Check that the monitor is powered up. Check that the video cable connecting the camera to the monitor is connected properly. The screen image is dim  Clean the lens using a soft, clean cloth.  Check that the light source is adequate. The screen image has poor contrast.  Adjust the monitor’s contrast knob.