User Guide

11
ENFORCER Mini PTZ Camera
SECO-LARM, U.S.A., INC.
Understanding and Operating Preset and Pattern Functions
Standard Pelco-compatible c
ontrollers allow the camera operator to do several functions without going through
the full OSD menu, depending on the capabilities of the DVR to which the camera is connected.
The SECO-LARM series of DVRs allows operators to do the following via the "Dome Preset" menu:
• Set the camera to remember multiple specific preset locations.
• Tell the camera to go to a specific preset location.
• Run certain preset functions, including patterns, swings, or grouped functions.
• Change certain configuration patterns.
Programming the patterns, swings, or grouped functions, and detailed configuration of the PTZ camera,
requires operators to use the OSD menu. See page 16 for more information.
This PTZ camera can be controlled by any DVR or keyboard controller which uses Pelco-compatible protocols.
When using non-SECO-
LARM DVRs, or when using keyboard controllers, the manuals for those devices may
include information on how to operate or program the PTZ camera.
To set or go to a Preset location or use a preset function via a SECO-LARM DVR:
1.
Press the "Dome" key. The lower left corner of the screen will change from "REC" to "DOME" to show the
camera is in the Dome Control menu.
2. Press the "1" key to go to the DOME PRESET menu.
3. Use the UP, DOWN, LEFT, and RIGHT buttons to highlight your selection and push ENTER to confirm
your selection.
Note: In most cases, only the GO function will work. Only the preset locations can be programmed via
the DOME PRESET menu. Other functions must be programmed using the OSD menu.
4. Use the UP and DOWN arrows to switch between YES and NO. Go to YES, and press the ENTER key.
See page 13 for a list of preset functions.