High Resolution Indoor Dome Cameras Manual EV-2660-NKBQ EV-2660-NKBAQ Features 550 TV Lines 3-Axis Gimbal Bracket 2.8~10.5mm Varifocal Lens Dual Voltage True Day & Night 36 IR LEDs EV-2660-NKBQ EV-2661-NKBQ EV-2660-NKBAQ Note: Model numbers that end with “Q” or that have a round green “Q” sticker signify RoHS-compliant products.
SECO-LARM High Resolution Indoor Dome Cameras Specifications EV-2660-NKBQ Type CCD Resolution Pickup elements Video ouput format Video output Lens Minimum illumination S/N ratio Sync White balance #IR LEDs IR wavelength IR range Power source LEDs off Current draw LEDs on Operating temperature Dimensions Weight EV-2660-NKBAQ EV-2661-NKBQ Indoor Dome Camera 1/ ” Sony Super HAD Color 3 Color: 520 TV Lines Color: 520 TV Lines B/W: 550 TV Lines 768x494 pixels NTSC 1.0Vp-p composite video, 75Ω 2.8~10.5mm, F1.
SECO-LARM High Resolution Indoor Dome Cameras Installation EV-2660-NKBQ or EV-2660-NKBAQ shown. Installation is the same for all three models. Mounting surface Female BNC connector (connect to video device) Base DC plug with terminal block Mounting screw Zoom DC Jack (connect to power) Important: Do not cut DC jack or BNC connector as warranty will be voided.
SECO-LARM High Resolution Indoor Dome Cameras Troubleshooting: The screen is blank. Check that the camera is powered up. Check that the power supply’s polarity is correct. Check that the monitor is powered up. Check that the video cable connecting the camera to the monitor is connected properly. The screen image is dim Clean the lens using a soft, clean cloth. Check that the light source is adequate. The screen image has poor contrast. Change the position of the camera. The screen image flickers.