EV-2125-N2WQ (NTSC) EV-2125-P2WQ (PAL) Mini Vandal Dome Camera Manual 1 /3 ” Sony Super HAD II CCD 2.9mm lens 420 TV lines Small 3” (76mm) diameter Weatherproof (IP65) Vandal-resistant design Note: Model numbers that end with “Q” or that have a round green “Q” sticker signify RoHS-compliant products.
ENFORCER Mini Vandal Dome Camera Specifications: Type CCD Resolution Lens size Pickup elements (HxV) Sync Video output Video output format S/N ratio Shutter control Gamma correction Gain control Minimum illumination Operating voltage Current draw Operating temperature Dimensions Weight EV-2125-N2WQ EV-2125-P2WQ Ultra-Mini Vandal Dome Camera 1/ ” Sony Super HAD II 3 420 TV lines 2.9mm 510x492 pixels 500x528 pixels Internal 1Vp-p composite video, 75Ω NTSC PAL >48dB (AGS OFF) Auto Electric Shutter (AES) 0.
ENFORCER Mini Vandal Dome Camera Overview: Camera Set screw Dome cover Mounting base Wiring notch Female BNC connector DC plug with terminal block DC jack Mounting screw Important: Do not cut DC jack or female BNC connector as warranty will be voided. Before Starting: 1. Please read this manual carefully and keep it for future reference. 2. Use the camera within given temperature and electricity limits. 3. Do not point the camera at the sun. Heat could damage the camera, even when not in use. 4.
ENFORCER Mini Vandal Dome Camera Troubleshooting: The screen is blank. Check that the camera is powered up. Check that the power supply’s polarity is correct. Check that the monitor is powered up. Check that the video cable connecting the camera to the monitor is connected properly. The screen image is dim. Clean the lens using a soft, clean cloth. Check that the light source is adequate. The screen image has poor contrast. Adjust the monitor’s contrast knob. Change the position of the camera.
