Specifications
ENFORCER 365-Day Annual Timer
SECO-LARM U.S.A., Inc 9 SECO-LARM U.S.A., Inc. 33 9
Password Reset:
1. Disconnect power from the SA-027HQ. If installed, remove the back-up batteries.
2. Within 30 seconds after power is reconnected, press all four function buttons (UP, DOWN, SET,
and ENTER) at the same time for approximately 5 seconds. If the buttons are not pressed
within 30 seconds, then the SA-027HQ will be unable to reset the password.
3. After the four function buttons are pressed for 5 seconds, “PASSWORD RESET” will appear for
1 second, followed by “NEW PSWD 0000” for 1 second, and then “ENTER PASSWORD”.
4. The password has now been restored to the factory default setting 0000.
5. Within 1 min. after “ENTER PASSWORD” is displayed, enter the new password. If no
password is entered, the SA-027HQ will exit password programming mode automatically.
6. No other programming changes have been reset, only the password.
7. For added security, it is recommended to change the password immediately.
Programming Password:
1. To set the password, press the SET button on the SA-027HQ until “ENTER TO SET CODE”
appears on-screen. Press the ENTER button to confirm the programming selection.
2. Using the UP and DOWN buttons, select “YES” or “NO”. Press the “ENTER” button to confirm
the selection. A confirmation screen will appear. Select “Y” to set the password or “N” to go back.
3. Using the UP and DOWN buttons, enter in the password you are changing.
EN T E R T O
SE T CO D E
O L D C OD E
0000
N E W C OD E
7291
PA S S W O R D
C O R R E CT
PA S S W O R D
0000
PA S S W O R D
C O R R E CT
OR
PA S S W O R D
YE S / N O
PA S S W O R D
C H N G Y /N
EN T E R
PA S S W O R D
EN T E R
PA S S W O R D
4. If the password is correct, use the UP and DOWN buttons to set a new password.
5. After entering the new password, press the ENTER button to accept the new password.
N E W C OD E
A C C E P T ?
Using Password Protection:
1. If the password protection is set, the password must be entered
every time programming mode is entered.
PA S S W O R D
ER R O R
N E W P S WD
0000
PA S S W O R D
R E S E T
EN T E R
PA S S W O R D
THE FACTORY DEFAULT
PASSWORD IS 0000.