User Manual

SPECIFICATIONS:
4,9, or 16 24VAC outputs:
Each individually fused (PTC**-type fuses)
Output PTC fuses rated 1.1 Amps
Individual red LED status indicator for each output
Main power switch to turn ON/OFF power to outputs
POWER:
Input: 120VAC, 60Hz
Output: 24VAC/100VA (2 x 100VA for EVP-1SA8P16UL)
UL approved
Total 4.0 Amps, (8 Amps for EVP-1SA8P16UL)
Main fuse rated 5.0 Amps @ 250VAC
Spare fuse included
6-foot power cord included
ENFORCER
®
Also available:
Installation Manual
EVP-1SA4P4UL (4 outputs @ 24VAC, 4Amps*)
EVP-1SA4P9UL (9 outputs @ 24VAC, 4Amps*)
EVP-1SA8P16UL (16 outputs @ 24VAC, 8Amps*)
EVP-1SD2P4UL 4 Outputs @ 6/12/24VDC, 2 Amps
EVP-1SD4P9UL 9 Outputs @ 6/12/24VDC, 4 Amps
EVP-1SD6P16UL 16 Outputs @ 6/12/24VDC, 6 Amps
ENCLOSURE:
Heavy-duty steel case to protect the power
connections
Removable steel cover for easy access to power
connections
Ventilation holes to prevent heat build-up
Dimensions - 10” x 7.75” x 3.5”
(254 x 196 x 89 mm)
Knock-out on the cover for optional cam lock
** Positive Temperature Coefficient
What it is:
The ENFORCER CCTV Power Supply centralizes the power sources
for four, nine, or sixteen AC-powered CCTV cameras and/or CCTV
accessories. The power input, power transformer, and all fused
power outputs are enclosed in one heavy-duty, easy-to-install
enclosure. As a result, an ENFORCER CCTV Power Supply can
replace up to sixteen individual power sources.
Note before installation:
The ENFORCER CCTV Power Supply is not waterproof or
weatherproof. Therefore, it must be mounted indoors where it
cannot be exposed to rain or other moisture.
Installation must be done by qualified personnel, and should
conform to local and all other applicable codes.
Installation:
1. Find a good location for the enclosure - The enclosure should
be mounted where it is out of sight and protected from
moisture and the weather, but where an authorized person
can have access for servicing in the future.
NOTE: Make sure the space where the enclosure is to be
mounted has adequate ventilation. Otherwise, heat buildup
inside the enclosure could damage the electronic parts or
cause the PTC fuses to trip needlessly.
2. Locate
the enclosure mounting holes. Using these holes as a
template, mark the location of the 4 screws on the wall with a
pencil. First fasten two
5
/
32
" x 1" (4 x 26mm) upper screws (not
included) until the gap between the wall and the screw head is
approximately 1/4" (6mm). Hang the enclosure on the 2 screws
using the enclosure's upper screw holes and adjust the proper
location of the enclosure. Then securely fasten the upper and
lower screws.
Knock-out
for optional
cam lock
Ventilation
Holes
(EVP-1SA4P9UL shown)
AC Power Supplies for CCTV Cameras and Accessories
*Total supply current, each channel output is fused at 1.1 Amp.
FIG. 1
AUDIO/VIDEO
APPARATUS
26BZ
Cable & Power
Knock-outs