User Manual

ENFORCER HDMI
®
Extender over Single Cat5e/6
SECO-LARM U.S.A., Inc. 5
EDID Management:
The MVE-AH030Q includes manual Extended Display Identification Data (EDID) management
settings to match the display settings to the source device. This setting is used when the display is
not properly displaying an image from the source device. Please see the below table for available
EDID settings.
1. Disconnect power from the MVE-AH030Q transmitter.
2. Adjust the EDID switch to the desired position.
3. Reconnect power to the MVE-AH030Q transmitter.
NOTE: If the image is still not displaying, then please restart from step 1 and choose a
different EDID switch position.
Position
EDID Description
0 (Default)
1080p, 2ch Audio
1
1080p, Dolby/DTS 5.1
2
1080p, HD Audio
3
1080i, 2ch Audio
4
1080i, Dolby/DTS 5.1
5
1080i, HD Audio
6
3D, 1080p, 2ch Audio
7
3D, 1080p, Dolby/DTS 5.1
8
3D, 1080p, HD Audio
9
Copy EDID from Transmitter HDMI Loop Output
A
Copy EDID from the Receiver HDMI Output
B
Not used
C
Not used
D
Not used
E
Not used
F
Not used
Bi-directional IR:
The MVE-AH030Q supports bi-directional IR pass-through signals. This allows for remote
operation of either the source device from the display location, or the display device from the
source locati
on. The MVE-AH030Q bi-directional IR Transmitter unit and IR Receiver unit support
signals from 20~60 kHz.
IR Transmitter
IR Receiver