Installation manual

ENFORCER Wireless Extender for HDMI®
SECO-LARM U.S.A., Inc.
HDMI® over Dual
Cat5e/6
HDMI® Matrix
Troubleshooting
WARRANTY This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for a period of one (1) year from the date of sale to the original consumer customer. SECO-LARM’s obligation is
limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect,
repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines
that such equipment is not operating properly as a result of causes other than defects in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential
personal or property damages of any kind to the purchaser or anyone else.
NOTICE: The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right
to change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2012 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in
whole or in part, without the written permission of SECO-LARM.
16842 Millikan Avenue, Irvine, CA 92606 Website: www seco-larm.com
Tel: [phone] Fax: [phone] E-mail: [e-mail]
MiMVE-WH010Q_1209.docx
PICHN1
Also Available from SECO-LARM:
4
 Make sure the transmitter and receiver are connected to power.
 Reset the receiver and transmitter. Use a pencil or small object
to hold the reset button of the receiver down for 3 seconds.
Repeat the same process for the transmitter.
 Shorten distance between the transmitter and receiver.
HDMI device does not function properly
HDMI® Switcher
HDMI® over Single
Cat5e/6
Component Video Baluns
Over Cat5e/6
Active VGA and Audio
Distributors over Cat5e/6
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in
the United States and other countries.