Data Sheet

Copyright 2013 © SECO-LARM U S A, Inc All rights reserved
The SECO-LARM policy is one of continual development For that reason, SECO-LARM reserves the right to
change prices and specifications without notice SECO-LARM is not responsible for misprints
PiSK-910R4Q.docx
16842 Millikan Ave, Irvine, CA 92606
Tel: [phone] • Fax: [phone]
[e-mail] • www.seco-larm.com
4-Channel RF Transmitters and Receiver
SK-919TP4J-NUQ 4-Button Pre-Coded Transmitter
SK-917TP4J-NU
4-Button CODEBUMP™ Transmitter
• Range: Up to 500ft (152m)*, 315MHz
• LED Transmission indicator
• Attractive slimline design
• Over 68 billion possible codes
• Includes 12VDC alkaline battery
• Compatible with all 315MHz SECO-LARM receivers
• SK-917TP4J-NU: Code changes every time transmitter button is pressed
SK-910R4Q Specifications:
Operating frequency
315MHz
Memory capacity
15 Transmitter button codes per
channel, 60 total
Operating voltage
11~24 VAC/VDC
Operating
current
Standby
8mA@12VDC
Active
30mA@12VDC
Relay contact rating
Form C 10A@24VDC/120VAC
Connectors
Screw terminals: Power (+,-),
1 relay per channel (NO/NC/COM)
Dimensions
5
5
/
16
”x3
15
/
16
”x1
1
/
8
” (135x100x28 mm)
SK-919TP4H-NUQ 4-Button Handheld Transmitter
• Range: Up to 500ft (152m)*, 315MHz
• Attractive slimline design
• Over 68 billion possible codes
• Includes two 3VDC lithium batteries
• Compatible with all 315MHz SECO-LARM receivers
• Visor clip and belt clip included. Belt-clip holster and wall-mount
bracket also available (model #: SK-9HBC)
• Low battery indicator – LED flashes when battery drops below 2VDC
SK-910R4Q 4-Channel Receiver
• Five programmable relay output modes:
- Timed
- Momentary (1, 2, 3, 4, 5, 10, 30, or 60 sec)
- Toggle (ON/OFF)
- Latch
- Validity
• 11~24 VAC/VDC Operation
• Range: Up to 500ft (152m)*, 315MHz
• Independently programmable outputs
• Controls garage doors, gates, house lights, alarm panels or other
devices via remote
• Four LEDs indicate RF reception, learn mode entered,
transmitter learned, memory cleared, and relay output mode
• Pushbutton programming, no need to cut jumpers
• Up to 15 transmitter button codes per channel can be learned
• Compatible with all 315MHz SECO-LARM transmitters
SK-919TP4J-NUQ
SK-919TP4H-NUQ
SK-910R4Q
*Actual range will vary greatly depending on the installation and operating environment
Also Available from SECO-L ARM
®
:
SK-91ERSD
Increase range up to 1,000ft
(304m)* with the Extended
Range Antenna