Data Sheet
Copyright 2015 © SECO-LARM U.S.A, Inc. All rights reserved.
The SECO-LARM policy is one of continual development. For that reason, SECO-LARM reserves the right to
change prices and specifications without notice. SECO-LARM is not responsible for misprints.
PiSK-910RB2Q.docx
16842 Millikan Ave, Irvine, CA 92606
Tel: 949-261-2999 / 800-662-0800 • Fax: 949-261-7326
sales@seco-larm.com • www.seco-larm.com
2-Channel RF Transmitters and Receiver
SK-919TD2A-UP 2-Button Pre-Coded Transmitter
SK-917T2A-UQ
2-Button CODEBUMP™ Transmitter
• Range: Up to 500ft (152m)*, 315MHz
• LED Transmission indicator
• Includes 12VDC alkaline battery
• Compatible with all 315MHz SECO-LARM receivers
• SK-919TD2A-UP: 68 billion possible codes
• SK-917T2A-UQ: 18 quintillion possible codes
SK-910RB2Q Specifications:
Operating frequency
315MHz
Memory capacity
15 Transmitter button codes per
channel, 30 total
Operating voltage
11~24 VAC/VDC
Operating
current
Standby
8mA@12VDC
Active
30mA@12VDC
Relay output modes
4-Sec momentary, 1-sec momentary,
toggle, latch, validity
Relay contact rating
Form C 10A@24VDC/120VAC
Connectors
Screw terminals: Power (+,-)
1 relay per channel (NO/NC/COM)
Dimensions
3
7
/
16
”x3
7
/
16
”x1
1
/
8
” (87x87x28 mm)
SK-919TP2H-NUQ 2-Button Handheld Transmitter
• Range: Up to 500ft (152m)*, 315MHz
• Over 68 billion possible codes
• Includes two 3VDC lithium batteries
• Compatible with all 315MHz SECO-LARM receivers
• Visor clip and belt clip included. Belt-clip holster and wall-mount
bracket also available (model #: SK-9HBC)
• Low battery indicator – LED flashes when battery drops below 2VDC
SK-910RB2Q 2-Channel Receiver
• Five programmable relay output modes:
- 4-Second momentary
- 1-Second momentary
- Toggle (ON/OFF)
- Latch
- Validity
• 11~24 VAC/VDC Operation
• Range: Up to 500ft (152m)*, 315MHz
• Independently programmable outputs
• Controls garage doors, gates, house lights, alarm panels or other
devices via remote
• Two LEDs indicate RF reception, learn mode entered,
transmitter learned, memory cleared, and relay output mode
• Pushbutton programming, no need to cut jumpers
• Up to 15 transmitter button codes per channel can be learned
• Compatible with all 315MHz SECO-LARM transmitters
SK-919TP2H-NUQ
SK-910RB2Q
*Actual range will vary greatly depending on the installation and operating environment
Also Available from SECO-LARM
®
:
SK-91ERSD
Increase range up to 1,000ft
(304m)* with the Extended
Range Antenna
SK-919TD2A-UP