User's Manual

2.2 Please wait 30 seconds after plugging in the camera to allow
it to initialize. The camera will begin rotating as part of its start
up sequence and the red LED light on the front will blink when
ready.
Note:
1. If the red LED light keeps on and does not blink for a long
time, Hold for 3 seconds to perform a factory reset. This will
reboot the camera and clear all settings to factory defaults,
including previously configured Wi-Fi settings, so you can set up
your camera again.
2. Never miss the moment-Put in a micro SD card to record and
save motion activated events, please insert the