User`s manual
Motion Sensing Shot
32
Performs shutter release when brightness variation
on image exceeds predefined level.
1. Move to the mode selection screen by pressing the Esc
button in any modes.
2. Select Motion Sensing Shot item, then press the Enter
button.
3. Motion Sensing Shot screen will be displayed with previously used parameters.
1. Operation Status : indicates the operation status of motion sensing shot.
2. Number of Shots in Progress : indicates the number of motion sensing shots
in progress.
3. Motion Sensing Status : indicates the status of each area. The left value of arrow
mark indicates the current brightness value, Arrow mark indicates increasing or
decreasing of brightness, and the right value of arrow mark indicates brightness
difference between previous brightness value and current brightness value.
4. Sound : indicates whether beep sound is produced or not.
5. Residual Time : indicates residual time or shots until the end of motion sensing shot.
Operation Mode selection (1.1)
□ Digital View Finder
□ Interval Shot(Simple)
□ Long Exposure(Bulb)
□ Long Exposure(Time)
□ Interval Shot(Advanced)
□ Motion Sensing Shot
□ General Setup
2
Operation Status
Motion Sensing Status
Sound
Number of Shots in Progress
Start Method/Residual Time
(Residual Shots)
20↑00 32↓01 34↑09
20↑00 32↓01 34↑09
20↑00 32↓01 34↑09
Sound ON Rest Time 00 00:00:10
PLAY 000000
3
20↑00 32↓01 34↑09
20↑00 32↓01 34↑09
20↑00 32↓01 34↑09
Sound ON Rest Time 00 00:00:10
PLAY 000001
1. Pressing the Enter button plays motion sensing shot,
then STOP is changed to PLAY. At the bottom of LCD,
residual time or shots until the end of motion sensing
shot will be displayed.
2. If the brightness difference exceeds the predefined
value, the shutter is released with beep sound.
3. Pressing the Enter button during PLAY suspends the progress of motion sensing
shot, and displays PAUSE. Pressing the Enter button again resumes play.
4. Pressing the Esc button during PLAY or PAUSE stops Motion Sensing shot.
1