User's Manual

Doc No.: A20450690 Rev.2 ECO 012029 Date: 06/29/16 10
The RTLS Multi Vision tag is used for UWB location information with use status button, door management and
cutband technology. It is intended to be applied to a patients ankle or wrist.
Applying the Tag to the Patient
Table 1 RTLS Multi Vision Tags
1. Remove the Tag from the Tag Storage Box.
2. Cut the needed length of strap from the strap reel (cut the strap at the center of the oval cut out as to better
feed the strap through the Tag latching mechanism).
3. Admit the infant’s information into the software with their name, room number, and any other identification
information that may be pertinent.
4. Begin feeding the strap up through the Tag on one side ensuring the silver conductive side of the strap is
facing the Tag. Only go to the first notch leaving enough strap to hold onto (See Figure 1.3). Repeat this step
for the other side of the Tag ensuring the loop is large enough to slide over the infant’s ankle. Once the strap is
in contact with the pins of the Tag, a green LED will light up on the tag indicating it is functioning.
XMITTR Part #
Description
Tester #
A20450900
13.56 MHz RTLS Multi Vision
A07300920
A20450930
6.78 MHz RTLS Multi Vision
A07390900
A20450950
40.68 MHz RTLS Multi Vision
A07300940
A20450960
40.68 MHz RTLS Multi Vision 12m
A07300940
SECTION 3 Using the Tags
Figure 1.1
31 foot spool
Figure 1.2
Cut strap in center of
oval.
Figure 1.3
Feed up to first notch