User's Guide

Doc No.: A22270692 Rev. B ECO: 13058 Date: 04/09/19 24
The Model SC-40 ID System was designed to assist your facility nursing staff with the difficult task of managing your residents, infants,
and assets. This system was designed to identify the transmitter, who the transmitter is assigned to, and what door the transmitter is near.
In order for the Model SC-40 ID System to provide this valuable information, the Nurse Station must first be programmed with all this
information. The following is a step by step procedure to assist while programming the ID Nurse Station.
Step 1
The ID Nurse Station display should read:
ID System Active
Inactive: 0 Version: x.xx
Step 2
Now enter *234, holding the 4 until the display
changes to this:
1 = Transmitters 2=Panels
* = More 9 = Quit >>
Step 3
Begin by entering all the transmitter data first. Enter
transmitter ID #, room #, then transmitter
description. Press “1” on the keypad. The display
should now read:
1 = Add\Modify 2 = Delete
3 = Show All 9 = Back >>
Step 4
Press “1” on the keypad. This next screen will prompt
you to enter the transmitter ID # first. See diagram
below for location of transmitter ID #.
Enter Transmitter ID#*= OK
ID# ----
Step 5
Once the transmitter ID has been entered into the
keypad, press “*”. The display should change to this:
Enter room # * = OK
Room # ----
Step 6
Now enter the infant’s room # and press “*” when
you are finished. The display should now read:
1 = up 2 = dn # = bk
* = OK
Name: ______________
Step 7
Enter the infant’s name. Press “*” when the letter is
correct and use “*” to enter a space between first and
last name. When complete, press “*” to change the
display to:
* = done 1 = more data entry
Selection: __
Step 8
If you have more infant data to enter, press “1” and
return to the beginning. When you are finished
entering all infant data, press “*” or wait 15 seconds.
The display will go back to the original system status
screen in Step 1.
APPENDIX A PROGRAMMING THE ID NURSE STATION WITH
TRANSMITTER INFORMATION