User's Manual

Doc. No.: A03490690 Rev.: 1 ECO: 12274 Date 11/10/2016 28
Figure 8 - RTLS Node Internal View
Care must be taken when removing the cover as the PCB is mounted on the cover. Any wiring must take into
account the need to remove the cover should the need arise.
 The node must be mounted using the 4 mounting holes located on the rear plate of the node, or the ceiling
clip.
 The larger hole is for data and power access however, if the node is wall mounted, either access hole may
be used.
 Mounting hardware is supplied with each node that will allow mounting in most cases.
 There are access holes in the mounting plate for data and power.
 There is no side access for these cables however one can be added to accommodate wiremold in the field.