User manual

Getting Started

Note

If you wish to retain your existing IP settings for this network connection, click Advanced

and Add the secondary IP address of 192.168.0.100, subnet mask 255.255.255.0.

Set up the SG unit’s password and LAN connection settings

Launch your web browser and navigate to 192.168.0.1.

Select Quick Setup Wizard from the center of the page.

A log in prompt is displayed. Enter the initial user name and password for the SG unit:

User name: root

Password: default

Note

If you are unable to browse to the SG unit at 192.168.0.1, or the initial username and

password are not accepted, press the black Reset/Erase button on the SG unit’s rear

panel twice, wait 20 – 30 seconds, then try again.

Pressing Reset/Erase twice within 2 seconds resets the SG unit to its factory default

settings.

Enter and confirm a password for your SG unit. This is the password for the user root,

the main administrative user account on the SG unit. It is therefore important that you

choose a password that is hard to guess, and keep it safe.