User manual

Virtual Private Networking
208
Enter the Internet IP address of the remote party in The remote party's IP address field.
In this example, enter: 209.0.0.1
The Endpoint ID is used to authenticate the remote party to the SG unit. The remote
party's ID is optional if it has a static IP address and uses Preshared Secrets for
authentication. It becomes a required field if the remote party has a dynamic IP or DNS
hostname address or if RSA Digital Key Signatures are used for authentication. It is
optional in this example, because the remote party has a static IP address. If the remote
party is a SG unit, it must have the form abcd@efgh. If the remote party is not a SG unit,
refer the interoperability documents on the SG Knowledge Base
(http://www.cyberguard.com/snapgear/knowledgebase.html) to determine what form it
must take. In this example leave the field blank.
Click the Next button to configure the Phase 1 Settings.
Other options
The following options become available on this page depending on what has been
configured previously:
• The remote party's DNS hostname address field is the DNS hostname address
of the Internet interface of the remote party. This option becomes available if the
remote party has been configured to have a DNS hostname address.
• Distinguished Name field is the list of attribute/value pairs contained in the
certificate. The list of attributes supported are as follows:
C
Country
ST
State or province
L
Locality or town
O
Organization