User manual

System
269
Enter the address of an Email Server (SMTP server) that accepts email for forwarding.
Enter the Email Address(es) to which to send the system log messages.
The Sender Email address that System Log messages are sent from.
Set the Filter Level to only send syslog messages at this level or above.
Specify the number of seconds to wait after recieving a system log message before
sending the an email in Delay to Send (s). This allows multiple system log messages to
accumulate before sending an email containing them all.
Messages per Email is the maximum number of system log messages that are allowed
to accumulate before sending the email. The default setting of 0 means unlimited, and is
typically appropriate for all systems but those that experience heavy traffic.
Click Submit to apply your changes.
Reboot and Reset
Rebooting does not erase your SG unit’s configuration, however network connections
such as your Internet connection, VPN tunnels, etc. are terminated and re-established
when the device is up and running again.