User manual

Getting Started
28
 You may choose to Obtain LAN IP address from a DHCP server on LAN if you
have an existing DHCP server, and wish to rely on it to automatically configure the SG
unit’s LAN connection settings (not recommended). Skip to the next step.
If you selected Manual configuration, some additional information is required.
Otherwise, skip to the next step.
Enter an IP address and Subnet Mask for the SG unit’s LAN connection.
Note
Take note of this IP address and subnet mask, as you will need them later on.
To enable the SG unit’s built-in DHCP server, enter a range of addresses to hand out in
DHCP Server Address Range. PCs and other hosts on your LAN that are set to
automatically obtain network settings are assigned an address from this range, and
instructed to use the SG unit as their gateway to the Internet and as their DNS server for
Internet domain name resolution.
Click Next.
Connect the SG unit to your LAN
Review your configuration changes. Once you are satisfied, click Finish to activate the
new configuration.