User manual

Getting Started
35
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Leave the Default gateway and DNS server addresses blank.
Set up the SG unit’s password and network connection settings
Launch your web browser and navigate to 192.168.0.1.
Select Network Setup from the Networking menu.
A log in prompt is displayed. Enter the initial user name and password for the SG unit:
User name: root
Password: default
Note
If you are unable to connect to the management console at 192.168.0.1, or the initial
username and password are not accepted, press the Reset button on the SG unit’s rear
panel twice, wait 20 – 30 seconds, and try again.
Pressing Reset twice within 2 seconds resets the SG unit to its factory default settings
Enter and confirm a password for your SG unit. This is the password for the user root,
the main administrative user account on the SG unit. It is therefore important that you
choose a password that is hard to guess, and keep it safe.
Note
The new password takes effect immediately. You are prompted to enter it when
completing the next step.