User's Manual

reinstalled and the integral transmitter sends a tamper restore to the Digital
Life Controller.
Battery Installation and Replacement
The SW-ATT-GB sensor includes low battery detection capability. When the
battery voltage reaches a pre-determined level the glass break detector will
send a low battery report to the Digital Life Controller. When the system
indicates that the sensor batteries are low, replace them immediately. Use the
recommended replacement batteries (See specification) or contact AT&T
technical support for more information.
To install the battery, do the following:
1. Carefully remove the Glassbreak detector from its base by twisting
counterclockwise.
2. Remove the depleted batteries and dispose of them as required by
local laws.
3. Insert the replacement batteries paying careful attention to the batteries
polarity.
6. Re-attach the glass break detector to its base. Match the alignment
marks and twist clockwise. If batteries are not installed, the detector
cannot be installed to its base.
General Specifications
Operating Temperature: 32° to 120° F (0° to 49° C)
Operating Rel. Humidity: 5 to 95%, non-condensing
Operating Frequency: 433.92 MHz
Battery Type: CR-123A, or equivalent Lithium
batteries, two required
Installation Kit: three (3) Philips head screws, three
plastic wall anchors
Sensor Type: Single microphone, dual stage—thud
and crash
Approved Glass Break Simulator: Intellisense Model FG-701
IMPORTANT INFORMATION ABOUT RADIO DEVICES
1. AT&T radio controls provide a reliable communications link and fill an important
need in portable wireless signaling. However, there are some limitations which
must be observed.