User's Manual

ManualsBrandsSecure Wireless ManualsElectronicsWireless Smoke Sensor

AT&T Model SW-ATT-SMKT SMOKE ALARM

DESCRIPTION

The SW-ATT-SMKT is a photoelectric smoke alarm

with a built-in transmitter designed for use with the

ATT Digital Life Controller system. When smoke is

detected, the alarm sounds a loud local alarm. Twenty

seconds after the local alarm sounds, the built-in

transmitter sends a digitally coded wireless signal to

the Control Panel. The wireless signal will be repeated

every 20 seconds as long as smoke is still present. In

addition to the photoelectric detector, the unit

contains an integrated fixed 135° temperature and

rate-of-rise heat sensor that will send an alarm signal

based on temperature detected.

INSTALLATION

1. Slide the battery compartment cover away from the

unit to unsnap it and lift it off. See Figure 2.

2. Observing proper polarity, insert the two 3V lithium

batteries supplied into the alarm battery

compartment and replace the battery cover.

3. Remove the red plastic dust cover from the unit.

4. Refer to Page 3 for selecting a proper location for

the smoke alarm.

5. Using the two screws and anchors provided, mount

the base.

6. Attach the unit to the base as follows:

• Line up the raised alignment tab on the lip of the

unit with the alignment arrow on the base. See Figure

• Insert the unit into the base and turn clockwise

approximately 15 degrees. It should snap firmly into

place.

IMPORTANT: The unit cannot be attached to the

base if no batteries are installed.

DISCOVER AND REGISTER THE SMOKE

DETECTOR

 Reference Section Error! Reference

source not found., “Enter Discovery

Mode for Device Detection” for

instructions on entering the discovery

mode.

 Click on the Start Discovery button to

enter the discovery mode on the DLC.

 Enroll the Smoke Detector by pressing

and holding the test button for a

minimum of two (2) seconds.

 Verify that the device appears on the

“Device Setup” page along with its

unique device ID.

Summary of content (4 pages)

PAGE 1
AT&T Model SW-ATT-SMKT SMOKE ALARM DESCRIPTION The SW-ATT-SMKT is a photoelectric smoke alarm with a built-in transmitter designed for use with the ATT Digital Life Controller system. When smoke is detected, the alarm sounds a loud local alarm. Twenty seconds after the local alarm sounds, the built-in transmitter sends a digitally coded wireless signal to the Control Panel. The wireless signal will be repeated every 20 seconds as long as smoke is still present.
PAGE 2
SENSITIVITY TEST 1. Press and hold the TEST/SILENCE button for 4 seconds. Once the test starts, the smoke alarm LED flashes 1 to 9 times. 2. Count the number of LED flashes and use the following table to determine if any action is necessary. FLASHES INDICATION ACTION 0-1 Unserviceable hardware fault. Reset and rerun sensitivity test. If the error persists, replace the unit. 2-3 Unit is becoming insensitive. Clean and reset the unit. Rerun sensitivity test. If the error persists, replace the unit.
PAGE 3
5. 6. 7. 8. 9. 10. Blow out or use a soft-bristled brush to remove all dust and dirt from the optical base. Line the new smoke chamber up with the optical base by lining up the arrows on the optical chamber to the latches on the optical base. Ensure that the LED cavity in the optical chamber is above the LED and snap the optical chamber down into place. To replace the alarm cap as follows: • Line the alarm cap up with the unit.
PAGE 4
IMPORTANT INFORMATION ABOUT RADIO DEVICES 1. 2. 3. 4. 5. 6. AT&T radio controls provide a reliable communications link and fill an important need in portable wireless signaling. However, there are some limitations which must be observed. For US installations only: the radios are required to comply with FCC rules and regulations including FCC part 15 devices. As such, they have limited transmitter power and therefore limited range.